Household Cable Instructions

Connection

1. Insert the connector into the CCS Type 2 socket.
2. After a short delay, the connector will lock in place (if the EVSE has a locking mechanism).
3. Once communication with the charger is established, the output will be enabled if the charger can supply at least 13 A of current.
4. Insert the plug or extension lead to power your required load.

Removal

1. Press the unlock button on the top of the connector.
2. Power will stop, and the lock will disengage.
3. Remove the plug.

This appliance is not intended for use by persons (including children) with reduced physical, sensory, or mental capabilities, or by those lacking experience and knowledge, unless they have been given supervision or instruction concerning the use of the appliance by a person responsible for their safety.

Children should be supervised to ensure they do not play with the appliance.

Maintenance

• Clean only with a damp cloth soaked in soapy water.
• Do not use alcohol-based cleaning agents.
• Do not disassemble or replace cords. Contact the manufacturer for repairs.

Troubleshooting

Power Does Not Engage

• Ensure the charger is powered and capable of supplying at least 3.3 kW.
• Check that the charger is not disabled by a schedule.
• Smart chargers with app control often have schedules set to charge at specific times. Disable these to use the device immediately. Common terms for this setting include: ‘Disable scheduling’, ‘Max charging’, ‘Smart charging’.

Connector is Stuck

• While pressing the connector into the charger, press the unlock button.
• When you hear a click, pull out the connector.
• This method helps to release tension on the locking pin.

Power Cuts Out

• If power cuts out under load, check that the load is not exceeding 13 A. The device will disable power if more than 13 A is drawn for over five seconds.
• If power cuts out within 30 seconds of plugging in (without load), the charger may be unable to supply sufficient power. Check that there is no current or power limit set in the charger’s app.

Specification

Input compatibility: For use only with CCS Type 2 electric vehicle supply equipment (EVSE) installed in accordance with local regulations. EVSE must meet IEC 61851-1 and have an output of at least 3.3 kW.

Output compatibility: BS 1363 fused plug only.

AC supply voltage: 240 V AC, 50/60 Hz.

AC supply current: Minimum 13 A.

Cable type: PVC, 3-core, 2.5 mm².

Protections: Monitors EVSE control limits; overload detection at more than 13 A for 5 seconds.

Country of manufacture: United Kingdom.

Manufacturer details: STN Power Products Limited, Hybrid Unit 1, 2 Turbine Way, Sunderland, SR5 3NZ. Email: info@oakev.co.uk.